What is the installation process?
If you have an automatic icemaker in your refrigerator, you’re already familiar with how we install.
1. We start out by finding the nearest cold water source. It’s usually located under a sink.
2. We install a tee fitting that allows the sink and the cooler to share the same line at once.
3. Then we attach our food grade waterway to the tee fitting. A small hole is cut in the back of the cabinet, and we “snake” our waterway inside the wall and to the ceiling. Once it’s above the drop ceiling, it’s easy to run it anywhere that you would like your Cooler.
4. Once we get the waterway above the cooler, we snake it back down the wall and out a small hole that is covered with a cable plate.
5. Finally, we just plug in the cooler and turn on the water under the sink. You are ready to enjoy years of hassle-free service.